Sharp MD-MT877H Mode D'emploi page 159

Error Messages : continued
ERROR MESSAGES MEANING
NO DISC
● A disc has not been loaded.
NO SIGNAL
● Poor connection of the digital cable.
● No output signal comes out from the connected unit
(noSIG.)
to playback.
● The input signal has improper sampling frequency.
● You recorded on a playback-only disc.
PLAY MD
(PLAYmd)
● The battery charger is defective.
POWER ?
● The write protection tab of a MiniDisc is set to the
PROTECTED
protected position.
● You tried to record on a playback-only disc.
● Since a track number is currently being located or
SORRY
(Sorry) updated, the unit cannot accept your command.
● The temperature is too high.
TEMP OVER
(TEMP!)
● There is an error in the recording signal.
TOC FORM **
(Tform**)
● There is no space left for recording character in-
TOC FULL
formation (track names, disc names, etc.).
● The track has been protected from being erased.
Tr. Protect
● A disc which contains data other than music was
? DISC
(? DISC) played.
● There is an error in the signal recorded on the disc.
● Stamping is not possible.
( ) : Error messages seen on the remote control.
Number or symbol appears in * position.
REMEDY
● Load a disc.
● Connect the digital cable securely.
● If the portable CD player has a function to prevent sound
skips, deactivate it.
● Playback with the connected unit.
● Replace it with a recordable disc.
● To have it repaired, go to the distributor where you pur-
chased the unit.
● Move the write protection tab back to its original position.
● Replace it with a recordable MiniDisc.
● Wait for a while and try the operation again.
● Turn off the power, and wait for a while.
● Erase all of the tracks, and then record again.
● Replace it with another recordable disc.
● Edit the track with the device on which it was recorded.
● A disc which contains non-music data cannot be played.
● Replace it with another recorded disc.
● Retry.
E-48