Sharp MD-MT877H Mode D'emploi page 151

Titling a MiniDisc : continued
5
When the unit displays "CHANGE MD", re-
move the master MiniDisc.
Remove it without turning off the power. Or, the op-
eration will be cancelled.
Operation of the MiniDisc for stamping
6
Load a MiniDisc for stamping.
7
Press the ENTER button.
The unit will finish recording the character informa-
tion and enter the stop mode.
Note:
If the total number of tracks on the master MiniDisc does not
match that on the MiniDisc for stamping, the unit will display
"Can't STAMP" and turn off the power.
If this happens, adjust the total number of tracks on the newly
recorded MiniDisc using the edit operation.
E-40