Sharp MD-MT877H Mode D'emploi page 121

About Power Source : continued
About the liquid crystal display (LCD)
The condition of the portable MD will be shown on the LCD
when inserting it into the battery charger.
Display Conditions
Charging.
Scrolling
The charging is complete.
When the portable MD is not inserted
correctly to the battery charger, or
Rechargeable terminal is dirty, it may
not be possible to charge the battery.
Turns off (Wipe the terminal by cotton swab.)
Refreshing.
The unit checks and, if necessary, dis-
charge the rechargeable battery to re-
charge it automatically. (At this time
battery indicator is flashing.)
About charging time
After about 3.5 hours have passed, "
The battery is charged up to 95% if it is completely dis-
charged.
Notes:
Charge the battery within the range of 5°C - 35°C (41°F -
95°F).
The unit can be left in the charging state after it is com-
pleted.
If the MiniDisc unit is not to be used for some time, re-
move the battery. (The battery drains gradually even when
the power is turned off.)
Carry the battery in the supplied case.
Caution:
Use the specified battery AD-N55BT only. Do not charge a
battery (nickel-cadmium, alkaline, etc.) other than that
specified.
Do not remove the outer cover of the re-
chargeable battery. It may cause heat gen-
eration, fire, or explosion.
Do not dip the battery in water, do not dis-
pose of it in a fire, and do not take it apart.
If the rechargeable battery terminal is dirty, charging may
not start. In such a case, wipe off the dirt with a dry cloth.
Do not disassemble the battery.
" will go out.
E-10