Programming And Starting Up; Controls And Commands; Connection To The Power Supply And Checking Of Motor Direction; Programming Of The Radio Code (Only With Plug Receiver Rsd-001) - Erreka ABC2M-009 Manuel De L'installateur

ABC2M-009_ES_FR_EN_PT_DE.book Page 47 Thursday, April 17, 2008 9:43 AM

PROGRAMMING AND STARTING UP

1

CONTROLS AND COMMANDS

2

CONNECTION TO THE POWER SUPPLY AND CHECKING OF MOTOR DIRECTION

1 Connect the main circuit breaker of the control
panel.

The correct operation of the operator and of the
complete system will only be achieved following the
programming. However, prior to programming it is
necessary to check that all the elements work,
carrying out the checks listed below.
3

PROGRAMMING OF THE RADIO CODE (ONLY WITH PLUG RECEIVER RSD-001)


When using the ERREKA RSD-001 plug-in receiver (trinary code 433Mhz) as the receiver for the remote control,
the radio code can be programmed in the control panel itself, as explained below. In the other cases, follow the
instructions of the plug-in receiver used.
Programming of the full opening radio code
SW1 General power supply switch
SW2 Programming micro-switches
ST1 Full opening and closing operations mini push
button
ST2 Pedestrian opening and closing operations mini
push button
PUL1 Opening mini push button M1
PUL2 Closing mini push button M1
PUL3 Opening mini push button M2
PUL4 Closing mini push button M2
V.M. Motor speed regulation potentiometer
T.E. Open gate waiting time regulation
potentiometer (only works in automatic mode)
T.LG Garage light duration regulation potentiometer
P.M1 Torque (force) regulation potentiometer for M1
P.M2 Torque (force) regulation potentiometer for M2
2 Check the motor direction using mini push buttons
PUL1, PUL2, PUL3 and PUL4.

If the direction of any motor is not correct,
interchange the connection cables (black cables) at
the corresponding connector for the motor.

Before carrying out any gate movement,
ensure there is no person or object in the radius
of action of the gate and the operation
mechanisms.
1 Connect the power supply of the control panel
(SW1 in "ON").
2 Close the leaves by pressing ST1.
3 Place DIP1 and DIP 4 in "ON"; DIP2, DIP3, DIP5 and
DIP6 in "OFF".

DL3 lights up, flashing.
4 Select the required code in the transmitter.
5 Press the channel to be used for full opening.

If the programming has been made correctly,
DL3 lights up permanently.
6 Place DIP1 and DIP4 in "OFF" (DL3 will go off).
English
47
Control panel ABC2M-009