Installation; Necessary Tools; Initial Conditions And Checks - Erreka ABC2M-009 Manuel De L'installateur

ABC2M-009_ES_FR_EN_PT_DE.book Page 44 Thursday, April 17, 2008 9:43 AM

INSTALLATION

1

NECESSARY TOOLS

Set of screwdrivers
Marker pencil
Tape measure
2

INITIAL CONDITIONS AND CHECKS

Initial installation conditions

Ensure the operator is correctly installed in the
gate.

It is necessary to have an earthed 230Vac, 50Hz,
current connection.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the current connection and installation
fulfil the following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automat
devices.
• The installation must be earthed.
44
Installation manual
Electric drill and broaches

Use the electrical drill in line with the use
instructions.

For proper operation, it is essential that the in-
ground central stop is in the gate closed position.

In order to program the travel of the gate, there
should also be mechanical stoppers in the gate open
position.

Check that the admissible environmental
temperature range for the control panel is
suitable for the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.
• The current connection point must be high
enough to be out of the reach of children.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic gate.