HumanTechnik cm-BT Mode D'emploi page 23

BA_CM_BT_0407
For some telephones, it might be necessary to make the connection manually
once the headset has been registered.
For more information, refer to your telephone's operating manual. You only
have to register the CM-BT headset on the telephone once. After that, the
CM-BT headset will be recognized automatically.
The CM-BT headset emits a signal and appears in the telephone menu that
displays all the Bluetooth devices currently registered on the telephone. The
CM-BT's blue status indicator will flash quickly.
Disconnecting the CM-BT headset from the telephone
Perform one of the following steps to terminate the connection between the
CM-BT headset and the telephone (e.g. when you want to connect another
Bluetooth device to the telephone):
• Switch the CM-BT headset off.
• Terminate the connection to the CM-BT headset in the telephone's
Bluetooth menu.
• Move the CM-BT headset to a position more than 10 meters away from
the telephone.
Please note: You do not have to delete the CM-BT headset from the tele-
phone's list of compatible devices to terminate the connection.
Reconnecting the CM-BT headset with the telephone
As soon as the CM-BT headset and the telephone have been disconnected,
e.g. if there is more than 10 meters between the two devices, the blue status
indicator will begin to flash slowly. The CM-BT headset will emit an audible
warning signal.
Once the CM-BT headset and the telephone are within range of one another
again, reconnect them by simply pressing the function key once. The blue
status indicator will begin to flash quickly – an audible warning signal will
be emitted when the devices have reconnected.
03.04.2007 8:49 Uhr Seite 23
English 23