Switching The Headset On/Off; How To Register The Headset On A Compatible Telephone - HumanTechnik cm-BT Mode D'emploi

BA_CM_BT_0407
How to register the CM-BT headset on a compatible telephone
Before you can use the CM-BT with the telephone, it has to be added to
the device list in the telephone. To do so, follow the instructions in the
telephone operating manual explaining how to activate Bluetooth.
3 Activate the Bluetooth function on the telephone and start your search for
Bluetooth devices. You will find the corresponding instructions in your
telephone's operating manual.
4 Select the CM-BT headset from the list of devices found. To register the
headset and establish a connection between the CM-BT headset and the
telephone, enter the following pass code: "0000".
22 English
03.04.2007 8:49 Uhr

Switching the headset on/off

Slide the on/off switch up (Position •).
After approx. 3 seconds, the device is ready to
connect. The blue LED will flash slowly.
If there is a device it has already been registered
with within range, the CM-BT will connect auto-
matically. Once the CM-BT headset has establi-
shed a connection, the blue status indicator will
flash quickly.
To switch the headset off, slide the switch down
(Position o).
1 Switch on your telephone and the CM-BT
headset.
2 Activate the "register mode" for the CM-BT
headset by holding the function key pressed
down for 6 seconds (status indicator will flash
blue/red quickly).
Seite 22