Setting The Phase Of Each Channel; Changing The Positions That Signals Are Sent To The Aux 1 Bus From Each Channel; Setting The Solo Function For All Channels - Tascam Model 12 Mode D'emploi

9 - Other functions

Setting the phase of each channel

The phase of each channel can be set.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 29)
2.
Select PHASE on the MIXER Screen, and open the PHASE
Screen.
3.
Select the channel with the signal phase to change, and
open its settings screen.
4.
Turn the MULTI JOG dial to change the signal phase.
Option Meaning
NORMAL (default) Normal phase
INVERT Inverted phase
5.
Press the MULTI JOG dial to confirm the setting.
The PHASE Screen reopens.
Changing the positions that signals are
sent to the AUX 1 bus from each channel
The positions from which signals are sent from the channels to
the AUX 1 bus can be changed.
This setting is shared by channels 1–6, 7/8 and 9/10.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 29)
2.
Select AUX1 SEND on the MIXER Screen, and open the
AUX1 SEND Screen.
54
TASCAM Model 12
3.
Turn the MULTI JOG dial to select the signal sent to the
AUX 1 bus.
Option Meaning
PRE FADER The signal is sent to the AUX 1 bus before
(default) adjustment by the channel fader.
The signal is sent to the AUX 1 bus after
POST FADER
adjustment by the channel fader.
4.
Press the MULTI JOG dial to confirm the setting.
The MIXER Screen reopens.

Setting the solo function for all channels

This sets the function of the SOLO switch.
This setting is shared by channels 1–6, 7/8 and 9/10.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 29)
2.
Select SOLO MODE on the MIXER Screen, and open the
SOLO MODE Screen.
3.
Turn the MULTI JOG dial to select the solo mode.
Option Meaning
Pressing the SOLO switch sends the
channel signal to the SOLO L/R bus.
PFL (default)
Use to check input signals before they
are affected by the MAIN MIX L/R bus.
Pressing the SOLO switch mutes the
signals of other channels.
INPLACE SOLO
Use to monitor signals from the MAIN
MIX L/R bus after they are affected by
channel faders and panning.
4.
Press the MULTI JOG dial to confirm the setting.
The MIXER Screen reopens.