Preparation For Work - Columbus TA 50 Mode D'emploi

The carpet cleaning machine TA 50│K 50 is designed to clean large areas of carpet or hard floor. In
the standard usage, the machine propels forward, cleaning a stripe of 50 cm (see paragraph Use as a
Self-contained Machine).
It is also possible to use TA 50│K 50 to clean small areas, with an additional hose and wand (see
Paragraph Use with Accessories).
The following steps 1 and 2 explain the necessary operations to prepare the machine for use:
1. Fill in the lower tank (solution tank) with cold or warm water, through the filling hole, adding a 5%
of not-foaming detergent (1/2 liter each 10 liters). Higher concentrations can be used in case of
particularly dirty carpet or hard floor.
Attention: wool carpet must be washed with cold water only!
2.
Insert the plug of the cable into a wall socket (see Safety Regulations).

Preparation for Work

12
TA 50│K 50
filling hole