Table des Matières
Publicité
Informations réglementaires relatives au sans fil
Des marquages règlementaires, sujets à la certification du pays, sont appliqués à l'imprimante hôte
signifiant que des approbations radio ont été obtenues. Pour obtenir une liste complète des pays
approuvés, allez à
United States
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including interference that may cause undesired operation.
Imprimante de panneaux signalétiques et d'étiquettes BradyPrinter J2000
www.BradyID.com/J2000compliance
AVERTISSEMENT !
Protocole radio
Fréquence de fonctionnement RF 13,56 MHz
Puissance de sortie RF
Type d'antenne
L'opération de cet appareil sans approbation
règlementaire est illégale.
Lecteur/graveur RFID conforme à ISO15693
< +20dBm EIRP (100Mw) < +23dBm (200mW)
Antenne PCB en boucle, 2,5
Conformité réglementaire
H @ 13,56 mHz
μ
34
Publicité
Table des Matières
