Troubleshooting - EMAK RIDER EL63 Manuel D'utilisation

7. TROUBLESHOOTING

PROBLEM
1. With the key on «START» the starter
motor does not run
2. With the key on «START» the starter
motor runs but the engine does not start
3. The engine stops
LIKELY CAUSE
Electronic card blocked due to:
– flat battery
– fuse blown
– bad earthing to the engine or the frame
– earth connections of the microswitches
disconnected
– badly earthed starter motor
– you are not ready for starting
– faulty fuel supply
– faulty ignition
Electronic card blocked due to:
– earth connections of the microswitches
disconnected
– flat battery
– badly connected battery (poor contact)
– engine badly earthed
SOLUTION
Turn the key to «STOP» and look for the cause
of the problem:
– recharge battery ( 6.2.3)
– replace fuse (10 A) ( 6.3.4)
– check connections of black earth leads
– check connections
– check earth connections
– check that the conditions allowing the start
are met ( 5.2.a)
– check the level in the tank (
– check the wiring of the fuel open command
– check fuel filter
– check that spark plug caps are firmly fitted
– check that the electrodes are clean and have
the correct gap
Turn the key to pos. «OFF» and look for the
cause of the problem:
– check connections
– recharge battery ( 6.2.3)
– check connections ( 3.5)
– check engine earth connection
5.3.3)
EN 31