End Of Work - EMAK RIDER EL63 Manuel D'utilisation

EL63 model:
– Use the 3rd gear only when moving the machine from
one area to the other.
ELV63 model:
– Only use maximum speed when moving the machine
from one area to the other.
5.4.6 Emptying the grass-catcher
The grass-catcher is full when the grass cuttings remain on the
lawn. If you continue mowing with the grass-catcher full, it
may block the collector chan-
nel.
To empty the grass-catcher:
1. lower the engine speed;
2. go into neutral (N)
( 4.4a or 4.4b) and stop
the machine's forward
movement;
3. disengage the blade
( 4.6);
4. engage the parking brake
on slopes;
5. hold onto the rear handle
and tip up the grass-
catcher to empty it;
NOTE
This
operation can only be done
with the blade disengaged,
otherwise the engine stops.
EN 22
5.4.7 Unblocking the collector channel
WARNING!
This job must only be performed with
the engine turned off.
If the collector channel gets blocked (due to accumulated
grass cuttings filling up the grass-catcher or an excessively
high speed with relation to the quantity of grass cuttings), you
need to:
1. stop forward movement immediately, disengage the blade
and stop the engine;
2. remove the grass-catcher;
3. remove the accumulated cuttings, reaching them from the
exit of the collector channel.
5.4.8 End of mowing
When you have finished mowing, disengage the blade, lower
the engine speed and ride the machine with the cutting deck
in the highest position.

5.4.9 End of work

Once you have finished mowing, stop the machine and
engage the parking brake.
Electric start:
1. shift the accelerator lever to «SLOW»;
2. switch off the engine by turning the key to «STOP»:
WARNING!
Always take out the ignition key
before leaving the machine unattended!