Connecting The Battery - EMAK RIDER EL63 Manuel D'utilisation

3.3 FITTING
THE SEAT
3
Fit the seat (1) onto the
plate (2) using the
screws (3).
3.4 FITTING THE
BLADE
ENGAGEMENT
LEVER
Fit the end of the lever
(1) on the projecting
part of the pin (2) and
fix it all by tightening
the screw (3) and nut
(4).
EN 10
2
3
1
4
3 2

3.5 CONNECTING THE BATTERY

Electric start models:
1. Position the battery (1) in its compartment under the
seat;
2. connect the battery connector (2) to the machine con-
nector (3);
3. fit the spring (4) to hold the battery in place;
1
4. recharge the battery by following the instructions in the
manual (
IMPORTANT
tery is fully charged!
WARNING!
instructions regarding safe handling and disposal.
6.2.3).
4 1
2 3
Never start the engine until the bat-
Follow the battery manufacturer's