Troubleshooting (Helps You To Quickly Solve Any Problems You May Encounter While Using The Machine) - EMAK EF 95 Manuel D'utilisation Et D'entretien

WARNING: always stop the machine and remove the key before carrying out any of the
corrective checks recommended in the table below, except when they require the unit to
be in operation.
When all the possible causes have been checked and the problem is not resolved, consult an
Authorised Service Centre. If a problem occurs that is not listed in this table, consult an Authorised
Service Centre.
PROBLEM
1. Engine does not
start.
2. Starter does not
work.
3. Reduction abnormal
engine speed.
13. TROUBLESHOOTING
POSSIBLE CAUSES
Lack of fuel.
Poor quality, contaminated fuel,
old fuel in tank.
Air filter contaminated.
No ignition spark.
To o m u c h f u e l i n e n g i n e
combustion chamber due to
repeated starting attempts.
Starter battery flat or weakly
charged.
Safety switch on operator's seat
does not function.
Safety switch on brake pedal
does not function.
Mower mechanism switched on. Switch off mower mechanism.
Fuse on (+) cable of starter
battery.
Grass too long or too wet.
Discharge channel/mower deck
blocked.
Air filter contaminated.
Carburettor setting incorrect.
Blade severely worn.
Driving speed too fast.
SOLUTION
Fill tank; check tank bleeding; check
fuel filter.
Always use fresh fuel from clean
containers; clean carburettor.
(Customer service workshop)
C l e a n a i r f i l t e r ( s e e o p e r a t i n g
i n s t r u c t i o n s f r o m
manufacturer).
Clean spark plug, use a new one if
necessary, check ignition cable, check
ignition system. (Customer service
workshop)
Unscrew spark plug and dry off
Charge starter battery.
Sit on operator's seat correctly; switch
defective.
Press brake pedal down fully.
Check fuse and fit a new one if
necessary.
Correct cutting height; make clearance
for mower mechanism by moving back
a short distance.
Clean discharge channel/mower deck.
Stop engine and take out ignition key!
C l e a n a i r f i l t e r ( s e e o p e r a t i n g
i n s t r u c t i o n s f r o m
manufacturer).
Have setting corrected.
(Customer service workshop)
Change blade.
(Customer service workshop)
Reduce driving speed.
GB
e n g i n e
e n g i n e
65