Preliminary Operations Before Starting Work; Seat Adjustment; Tyre Pressure - EMAK RIDER EL63 Manuel D'utilisation

5.3 PRELIMINARY OPERATIONS BEFORE STARTING
WORK
These controls ensure that the work gives the best results and
is done in maximum safety.

5.3.1 Seat adjustment

Adjust the seat by sliding it
along the bracket slots.
1. Loosen the four screws (1);
2. once you have found the
right position, securely
tighten the four screws (1).

5.3.2 Tyre pressure

Having the correct tyre pressure is essential for ensuring that
the cutting deck is perfectly horizontal and thus mows evenly.
1. Unscrew the valve caps;
2. Connect a compressed air line with a gauge to the valves
and adjust the pressure to the indicated values.
3. Screw the valve caps back on.
1
1
1,3 bar
1,8 bar
5.3.3 Filling with oil and fuel
DANGER!
Refuelling should be carried out in an
open or well-ventilated area with engine stopped.
Always remember that petrol fumes are inflammable. DO
NOT TAKE A NAKED FLAME TO THE TANK'S OPENING
IN ORDER TO SEE THE TANK'S CONTENTS AND DO
NOT SMOKE WHEN REFUELLING.
NOTE
The type of oil and fuel to be used is
given in the engine manual.
With the engine
stopped, check its oil
level.
1. to reach the plug
(1), remove the
engine cover (2)
with the aid of a
screwdriver;
2
EN 17