EMAK RIDER EL63 Manuel D'utilisation page 70

PROBLEM
4. The engine does not start
5. The engine stops
6. Starting is difficult or the engine runs
erratically
7. Weak engine performance during cutting
8. Engine stops when blade is engaged
9. Uneven cut and poor grass collection
EN 32
LIKELY CAUSE
– earth connections of the microswitches
disconnected
– you are not ready for starting
– faulty fuel supply
– faulty ignition
– earth connections of the microswitches
disconnected
– fault in carburation
– forward speed too high in relation to cutting
height
– you are not ready to engage the blade
– cutting deck not parallel to the ground
SOLUTION
– check connections
– check that the conditions allowing the start
are met ( 5.2.a)
– check the level in the tank (
– check the wiring of the fuel open command
– check the fuel filter
– check that spark plug caps are firmly fitted
– check that the electrodes are clean and have
the correct gap
– check connections
– clean or replace the air filter
– flush out the float chamber
– empty fuel tank and refill with fresh fuel
– check and, if necessary, replace fuel filter
– reduce the forward speed and/or raise
the cutting deck ( 5.4.5)
– check that the safety requirements are met
( 5.2.b)
– check the tyre pressure ( 5.3.2)
5.3.3)