Description Of The Controls; Assembling The Motorhoe - EMAK MZ2065 Manuel D'utilisation Et D'entretien

DESCRIPTION
OF THE CONTROLS
1) Hand throttle control lever.
2) Hoeing gear control lever
(safety device).
3) Handle for manual start
(recoil device).
4) Drawbar for tilling adjustment
(adjustable).
5) Tiller (with widening).
6) Tiller protection plate.
7) Reverse gear control lever
(where applicable).
8) Handles vertical adjustment knob.
9) Handles vertical and horizontal adju
stment lever (where applicable).

ASSEMBLING THE MOTORHOE

(Fig. 3)
Unless otherwise agreed, the Motorhoe
is delivered disassembled and put into
an appropriate packing. To complete the
assembly of the Motorhoe, follow the
procedures mentioned below:
Transfer Wheel
- Fix the wheel support with the appro-
priate pin (3) and split pin (4) (Fig. 3)
- Transport position "A"
- Working position "B"
Transport position must have pin 1
mounted as shown in Fig. 3.
To obtain the working position, remove
split pin 2, withdraw the pin and rotate
the support, thereafter insert the pin with
the split pin.
(Fig. 2)
fig.3
20
fig.2