Function Test; Switching On The Device - Geberit AQUACLEAN SELA Instructions De Montage

EN

Function test

Putting the remote control
into operation
If several devices of the same type are
installed in immediate proximity (e.g. in
hotels), the remote control must be
assigned. → See "Re-assigning the remote
control", page 34.
1
Detach the wall-mounted holder.
2
Open the battery compartment and insert
battery.
32

Switching on the device

Prerequisite
– The device has been mounted and connected.
– The spray shield has been mounted.
– The upper design cover has been mounted.
– If the interface module for flush actuation has
been installed as an option: all the plugs are
connected.
1
Open the water supply at the ball valve.
If there is no direct mains connection,
connect the mains plug.
45035999965553803-1 © 02-2019
970.057.00.1(00)