Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
in the wooden
ic board of a French
window or panel
•
Fit the wall flange B1 into the hole.
•
Fit the hose B2 into the wall flange B1 as shown in fig. 4.
•
When the hose B2 is not connected, the drilled hole can be
closed with the flange cap B1.
4
•
When installing the air conditioner, you should leave a door
slightly open little as 1/2" (1 cm) to guarantee correct
ventilation and room pressure.
•
Keep the air hoses as short and free of curves as possible to
avoid constrictions.
Note:
•
As special tools are required for this type of
installation, we suggest you have the appliance in-
stalled by specialized personnel.
in the wall:
you are
recommended to insulate
the section of wall using
suitable insulation
max 39 in
max 100 cm
min 14 in
min 35 cm
AIR CONDITIONING WITHOUT INSTALLATION
You can also set-up in a double-hung window:
•
Place the window brac et in the window sill, extend the
brac et fully within the window frame, fix the brac et by
using the pin then lower the window onto the brac et.
(Should the window brac et be too large for the window,
the plastic can be cut with a saw by a qualified profes-
sional.)
•
Fit the air exhaust hose B2 in the relevant housing located
on the rear side of the appliance. (fig. 1).
•
Connect the window outlet B3 to the other end of the ex-
haust hose.
•
Insert the window outlet B3 of the exhaust hose into the
slot of the window brac et (fig. 5).
5
Other set-up methods:
•
Than s to the loc ing pins, it's possible to use the window
brac et also for sliding windows. Position the hole of the
brac et so to allow a correct installation of the exhaust hose
(see figure 6).
6
6
Publicité
Table des Matières
