Electrical Connection; Complete The Installation - Elica ECL630S4 Guide D'utilisation, D'entretien Et D'installation

5 Push the right end of the motor mounting plate up and
snap it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
A. Motor mounting plate
B. Spring clip
6 Align mounting holes and install 6 x 16 mm screws and
6.4 mm lock washers
B
A. Screw with lock washer
B. Mounting hole
7 Attach power supply connector from the range hood to
the connector on the blower motor assembly wiring box.
A
B
A. 4- 4x8 mm mounting screws
B. Security screws
A
B
A

Electrical connection

I WARNING
ELECTRICAL SHOCK HAZARD.
DISCONNECT POWER BEFORE SERVICING.REPLACE ALL
PARTS AND PANELS BEFORE OPERATING. FAILURE TO DO
SO CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
• Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction box.
A
B
C
D
A. White wires
B. Black wires
C. UL listed wire connector
• Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and ordinances,
in 1 ⁄ " conduit from service panel to junction box.
2
I WARNING
ELECTRICALLY GROUND BLOWER. CONNECT GROUND WIRE
TO GREEN AND YELLOW GROUND WIRE IN TERMINAL BOX. FAI-
LURE TO DO SO CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
• Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
• Close and secure junction box cover.
Complete installation
Replace filters and check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house
fuse blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the "Maintenance" section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
E
F
D. Green (or bare) and yellow-green
ground wire
E. Home power supply cable
F. UL listed or CSA approved ½" strain relief
11