Maintenance - Elica ECL630S4 Guide D'utilisation, D'entretien Et D'installation

Maintenance

Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel
wool or soap-filled scouring pads. Do not use chlorine base
cleaners. Rub in direction of the grain line to avoid scratching
the surface.
Always wipe dry to avoid water marks.
• Stainless Steel Cleaner and Polish.
• Mild liquid detergent and water.
• Wipe with damp soft cloth or nonabrasive sponge, then
rinse with clean water and wipe dry.
Metal filters and drip trays:
1. Use 2 hands to remove filters.
2. Grasp filter handles, pull toward the front of range hood
and pull down on the rear handle to remove. Repeat for
each filter.
A
A. Grease filter
3. Remove grease drip tray.
A
4. Place the drip tray bracket using the screws included.
C
B
A
5. Wash metal filters and grease trays as needed in
dishwasher or hot detergent solution to clean.
6. Replace grease drip tray.
7. Reinstall filters, grasp filter handles and place front edge
of filter into the hood.
A. Drip tray
A. Drip tray
B. Drip tray bracket
C. Drip tray bracket screws (2)
8. Push up on the back handle and set rear of filter into the
drip tray to secure. Repeat for each filter.
A
Replacing a LED Lamp
Turn off the range hood and allow the LED lamp to cool.
To avoid damage or decreasing the life of the new lamp, do
not touch lamp with bare fingers. Replace lamp, using tissue
or wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1 Disconnect power.
2 Push up on the lens and turn it counterclockwise.
3 Remove the lamp and replace it with a 120-volt, 7.5 W watt
maximum halogen lamp with a GU10 base. Turn it clockwise
to lock it into place.
4 Repeat steps 2-3 for the other lamps if needed.
5 Reconnect power.
A. Grease filter
13