Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN-5
Press the right 0/T button to accept the weight as liquid weight. The density is calculated and result and [gCC] are
shown alternately.
Press the right 0/T button to stop the blinking and go back to ready status.
Begin Density Liquid mode-The display shows [Air] and [wWeigHt] alternately. Place the sinker on the on density
determination kit, the display shows the weight value.
Press the right 0/T button to accept the weight as air weight.
The display shows [Liguid] and [wWeigHt] alternately. Place the sinker on the density determination kit (in the
liquid), please make sure that the entire sinker is submerged in the liquid, the display shows the weight value.
Press the right 0/T button to accept the weight as liquid weight. The density is calculated and result and [gCC] are shown
alternately.
Press the right 0/T button to stop the blinking and go back to ready status.
3.6 Weigh Below Feature
Remove Weigh Below Cover
4. SETTINGS
4.1 Menu Navigation
.CAL.
.SETUP.
InCal*
AZSM
SPAN
FILTER
**
LINEAR
A.TARE
CAL ADJ
GRAD
END.CAL
GBL RST
END.SET
* InCal models only
** Not available in InCal models
Attach wire or string to Hook
.MODE.
.UNIT.
COUNT
COUNT
GRAM
PERCENT
MILLIGRAM
APWOPT
DYN
KILOGRAM
PERCENT
DENSITY
END.MOD
OUNCE
END.MOD
POUND
NOT ALL
CUSTOM
UNITS
SHOWN
NO
NOT ALL
UNITS SHOWN
YES
END.UNIT
Suspend sample
.END.
.PRINT.
.RS232.
OUT STA
BAUD
A. PRINT
PARITY
CONTENT
HAND.SH
LINE FO
END.R232
END.PRT
™
Pioneer
.LOC.
CAL
SETUP
MODE
UNIT
PRINT
RS232
END.LOCK
Publicité
Table des Matières
