Fault Rectification - SilverCrest SKM 500 B1 Mode D'emploi

4) Slide the cutting knife
knife
5) Place the drive shaft adapter
disk
6) Place the disk adapter
7) Close the lid
Fault rectification
DEFECT
The appliance
does not work.
The appliance
stops suddenly.
The motor runs, but
the accessory parts
do not rotate.
SKM 500 B1
with the knife guard
over the drive shaft
) at the side next to the drive shaft
with the disk fitted onto the drive shaft
and slide the pusher
CAUSE
The plug is not
connected.
The appliance is not
correctly assembled
and engaged.
The appliance is
defective.
The lid of the
appliance may have
become loose when
processing hard
ingredients.
The appliance is
defective.
The drive shaft
not inserted properly.
fitted and the kneading
onto the emulsifying disc
and 2 disks (e.g. cutting
in the mixing bowl
into the filling shaft
SOLUTION
Insert the plug into a mains
power socket.
Check the assembly of the
appliance and ensure that all
marks are correctly aligned.
In this case, contact the
Customer Services.
Replace the lid
In this case, contact the
Customer Services.
Check the assembly of the
is
drive shaft
.
and shredding
.
.
.
.
.
117
GB