Makita FS2500 Manuel D'instruction page 5

Reversing switch action
1
A
B
► 1. Reversing switch lever
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever
to the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
Hook
1
► 1. Hook
The hook is convenient for temporarily hanging the tool.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
To remove the bit, first remove the locator by pulling
the lock ring away from the gear housing. Then pull the
magnetic socket bit.
1
2
► 1. Lock ring 2. Gear housing
To install the magnetic socket bit, insert it into the tool
as far as it will go. Then install the locator by pushing it
firmly back onto the gear housing.
2
► 1. Lock ring 2. Magnetic socket bit 3. Gear housing
OPERATION
Fit the screw on the point of the bit and place the point
of the screw on the surface of the workpiece to be fas-
tened. Apply pressure to the tool and start it. Withdraw
the tool as soon as the clutch cuts in. Then release the
switch trigger.
5 ENGLISH
1
3