Connecting The »Cm-Bt2« To A Compatible Computer; Neckloop Safety Closure; Appendix; Safety Notes - HumanTechnik CM-BT2 Mode D'emploi

Connecting the »CM-BT2« to a compatible computer
1. Switch your computer on and ensure that the Bluetooth
hardware on the computer is activated. Switch on the »CM-BT2«.
2. Press the function key 4 on the »CM-BT2« for approx. 6 seconds
until the blue and red status indicator flashes alternately. The »CM-
BT2« remains in pairing mode for 2 minutes.
3.
Run the Bluetooth software on the computer. Follow the software
instructions to connect the »CM-BT2«.
4.
Select the »CM-BT2« from the list of devices that are found. If
necessary, enter the password „0000" to pair the »CM-BT2« and the
computer and establish a connection.
5.
If the pairing is successful, the blue status indicator on the »CM-BT2«
flashes four times quickly and the teleloop and headphones will say
the words „Connected".
We regret that we are not able to provide telephone support for any problems
you may encounter when operating this device with your PC

Neckloop Safety Closure

Please make sure that the safety closure of the neckloop is completely closed,
to ensure that it functions properly.
26 English

Appendix

Safety notes

The »CM-BT2« has been built using state-of-the-art technology and in ac-
cordance with recognized saftey standards.
Please note the following safety instructions:
• Never expose the device to the following:
- Sources of heat
- Direct sunlight
- Moisture / dampness
• Protect the device against contact with water, dust, harsh fluids and
steam.
• Only plug the connection cord into the corresponding jack.
• Connect only approved accessories.
• No changes to the communications system, neither technical nor non
technical, are permitted.
• The »CM-BT2« communications system contains small parts that
could be easily swallowed. Keep out of the reach of children under 3
years of age.
The manufacturer cannot be held liable for any damages or personal injury
whatsoever caused by the inappropriate use or misuse of the device.

Maintenance and care

The »CM-BT2« headset does not require any maintenance. If the unit does
become dirty, simply wipe it clean with a soft, damp cloth. Never use spirits,
thinners or other organic solvents.
Do not set up the »CM-BT2« where it will be exposed to full sunlight for long
periods.
In addition, it must be protected against excessive heat, moisture and severe
mechanical shocks.
Note: This product is not protected against splash water. Do not place any
containers filled with water, such as flower vases, or anything with an open
flame, such as a lit candle, on or near the product.
English 27