Toparc FE-200 Mode D'emploi page 45

Masquer les pouces Voir aussi pour FE-200:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FES-200
11 Disassembly
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Disconnect the mains plug.
• Always wear your personal protective equipment when dismounting the system.
• The personal protective equipment includes protective clothing, safety goggles, respirator mask
• Nobody without personal protective equipment may stay near the fume extraction system when it is
• It is not allowed to clean the fume extraction system using compressed air or a hammer.
NOTICE
• Disassembly must only be carried out by qualified personnel (in Germany, see TRBS 1203).
12 Disposal
For disposal, observe the local regulations, laws, provisions, standards and guidelines.
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.
12.2 Consumables
Oil, grease and cleaning agents must not contaminate the ground or enter sewage systems. These materials
must be stored, transported and disposed of in suitable containers. Observe the relevant local regulations
and disposal instructions of the safety data sheets specified by the manufacturer of the consumables.
Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with the
information provided by the manufacturer of the consumables.
The disposal of dust collecting bags is subject to special waste regulations. The dust must not enter sewage
systems or be disposed of together with normal household waste. Please observe the local and official
regulations.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
DANGER
CAUTION
Class P3, protective gloves and safety shoes.
being disassembled.
11 Disassembly
EN - 21

Publicité

Table des Matières
loading

Table des Matières