Electric Shock - Toparc FE-200 Mode D'emploi

FES-200
6.3 Establishing the electrical connection

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Mains cable and mains plug are pre-mounted. For the mains voltage and the fuse protection, please refer to:
 3.1 Technical Data on page EN-9
 3.3 Nameplate on page EN-10
1 Plug in mains plug.
7 Operation
Hazard due to overheating
Increased wear to the electric motor due to overheating.
• A cool-down period of at least 5 minutes must be observed for every 30 minutes of operating time.
• This value may change depending on the ambient temperature of max. 25°C.
• Provide sufficient ventilation during operation of the extraction system FES-200.
 Fig. 6 Operating elements on page EN-18
1 Plug the mains plug into the socket.
2 Set the rocker switch (2) on the fume extraction system to the Manual position.
WARNING
WARNING
CAUTION
7 Operation
EN - 17