Brandt TV220 Série Guide D'utilisation Et D'installation page 5

Copie de 9962 5591.qxd
Connection
If the cable is damaged, it must be replaced by the manufacturers, their After Sales Service or another
similarly qualified person for avoiding any possible risk of accident.
When the power is
code appears on the control panel. This disappears automatically after
about 30 seconds
panel. This is normal, as the display is for use by the after-sales service when required. The user must not
take this into account under any circumstances.If the unit has a 3 phase 400 V2N connection, and is not
working correctly, check that the neutral wire is correctly connected. This precaution should also be taken
for all your other electronic apparatus.
230V
1
L1
2
3
N
4
You must use a 32
Amp fuse on your ins-
tallation
18/10/02 10:36 Page 5
Installing your hob in complete safety
switched on, or after
or as soon as any
Your hob must be connected to the mains with:
400v 2N
- A H05RRF type cable with three 2.5 mm² conduc-
tors or five 1.5 mm² conductors (including a yellow /
green earth wire)
-
L1
1
recommendations or an all-pole circuit breaker with
contacts that open by at least 3 mm.
2
L2
3
N
4
You must use a 16
Amp fuse on your ins-
tallation
5
a long power failure,
touch control is touched
A plug that complies
230 V∼ ∼ 50 Hz
Total energy consumption:
TV220.....6,2 kW
TV223.....6,9 kW
a light
on the
to CEI 83