Technical Data; Intended Use - Festool ETS 125 EQ Guide D'utilisation

c) Disconnect the plug from the power
source before making any adjustments,
changing accessories, or storing power
tools. Such preventive safety measures re-
duce the risk of starting the power tool ac-
cidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tools op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner intended
for the particular type of power tool, tak-
ing into account the working conditions
and the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation.
5) Service
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
TO REDUCE THE RISK OF
INJURY, USER MUST READ AND UNDER-
STAND INSTRUCTION MANUAL.
Various dust created by power
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known (to the State of California) to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals
are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products,
• Arsenic and chromium from chemically-
treated lumber.
The risk from these exposures varies, depend-
ing on how often you do this type of work.
To reduce your exposure to these
chemicals work in a well ventilated
area and use approved safety equip-
ment, such as dust masks that are
specially designed to fi lter out micro-
scopic particles.

Technical data

Wattage
No load speed
No. of strokes
Sanding stroke
Sanding base
Weight
Safety level
Symbols
V volts
A amperes
Hz hertz
W watt
~ alternating current
n no load speed
0
Class II Construction
rpm revolutions per minute
spm strokes per minute

Intended use

The sanders are designed for sanding wood,
plastic, composite materials, paint / varnish,
fi lling material and similar materials. Metal
and materials with an asbestos content must
not be processed with these tools.
The machine is particularly suitable for
processing smaller surfaces and overhead
work because of its size, its weight and its
output.
The machines must not be damp nor operated
in a damp environment for electrical safety
reasons. The machines may only be used for
dry sanding.
3
200 W
5000 - 14000 rpm
10000 - 28000 spm
2.0 mm (0.079 in.)
Ø 125 mm (4.9 in.)
1.1 kg (2.4 lbs.)
/ II