Replacing Light Bulb - Metabo HPT C 18DSL Instructions De Sécurité Et Mode D'emploi

(3) While holding the lower guard lever to keep the lower
guard fully retracted into the saw cover, remove the
saw blade (Fig. 16).
Saw cover
2. Mounting the Saw Blade (Fig. 17)
WARNING
If the left-hand bolt is worked using other
tools than the provided box wrench, excessive
tightening and insuffi cient tightening may take
place, resulting in injury.
○ Take procedures here that are contrary to the
detaching procedures.
Left-hand bolt
Washer (B2)
NOTE
● Thoroughly remove any sawdust which has
accumulated on the spindle, bolt and washers.
● To assure proper rotation direction of the saw blade,
the arrow direction on the saw blade must coincide
with the arrow direction on the saw cover.
● Using the fi ngers, tighten the left-hand bolt retaining
the saw blade as much as possible. Then depress the
lock lever, lock the spindle, and thoroughly tighten the
left-hand bolt.
Saw blade
Lower guard lever
Fig. 16
Washer (A1)
Ring
Spindle
Concave
Saw blade
Fig. 17
CAUTION
After mounting the saw blade, reconfi rm that
the lock lever is fi rmly secured in the prescribed
position.

REPLACING LIGHT BULB

WARNING
● Make absolutely sure that the battery is removed
from the main body before replacing the light
bulb.
● Immediately after the light is turned OFF, the
bulb retains high temperature. Make sure to cool
down the light bulb thoroughly before replacing
it so as to prevent burns.
CAUTION
When replacing the light bulb, check the shape
of base as well as the rating (12 V, 5 W), and then
carry out perfect mounting. Otherwise, the light
bulb can come off and/or cause overheat.
1. Detaching light bulb
(1) Remove the convex part of the light cover from the
concave part of the housing, and then pull out the
light cover in the arrow-marked direction as shown in
Fig. 18.
Light cover
Housing
Fig. 18 <Side View>
English
Convex
Concave
17