Mounting And Dismounting The Saw Blade - Metabo HPT C 18DSL Instructions De Sécurité Et Mode D'emploi

English
Wing-bolt
Fig. 12 Not inclined
Inclined
gauge
Wing-bolt
NOTE
When using the saw at the inclination of 45 degrees,
use both the marks of on the bevel plate and [45] on
the inclined gauge of the base (Fig. 14).
What's more, if it is absolutely essential to use the
saw at a precise angle, make adjustment using a
protractor, etc.
Bevel plate
Inclined
gauge
16
Guide
Cutting line
(at 45 degrees)
Fig. 13
Wing-bolt
Fig. 14
(3) Ensure that the switch is turned to the ON position
before the saw blade comes in contact with the
lumber. The switch is turned ON when the trigger
is squeezed; and OFF when the trigger is released.
Moving the saw straight at a constant speed will
produce optimum cutting.
CAUTION
● Before starting to saw, ensure that the saw blade
has reached full speed revolution.
● Should the saw blade be stopped or made an
abnormal noise during operation, turn off the
switch immediately.
● When fi nished with a job, pull out the battery
from the main body.
● Twisting and forcibly pressing the saw during
cutting can result in unreasonable pressure on
the motor, so try to go straight quietly.
● In the situation where the circular saw is
continuously operated while replacing the
battery with stocked spare batteries one after
another, the motor tends to overheat. Therefore,
whenever the housing becomes hot, give the saw
a break for a while.
● Avoid cutting operation in a state where the base
bottom is afl oat from the material being cut.
Otherwise, the motor can get locked.
MOUNTING AND DISMOUNTING THE SAW
BLADE
CAUTION
To avoid serious accident, ensure the switch is in
the OFF position, and pull out the battery.
1. Dismounting the saw blade
(1) Set the cutting volume at maximum, and place the
Circular Saw as shown in Fig. 15.
Loosen
Lock lever
(2) Depress the lock lever, lock the spindle, and remove
the left-hand bolt and washer (B2) with the box
wrench.
Box wrench
Tighten
Fig. 15