General Information; Safety Information; Use Of Hazard Information - Hach 1735 TRO Manuel D'installation

Specifications
Specifications are subject to change without notice.
Note: All other specifications are the same as for instruments installed in non-hazardous locations. Refer to the
specifications in the 1735 TRO Analyzer User Manual.
Specification
Certifications
Enclosure ratings
Supply connection
Operating environment

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.

Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
Indicates a potentially hazardous situation that may result in minor or moderate injury.
Indicates a situation which, if not avoided, may cause damage to the instrument. Information that requires special
emphasis.
Details
ATEX EC-Type certified
EN 60079-0, EN 60079-11
Upper enclosure: IP64
Lower enclosure: IP20
Over voltage Category I
Pollution Degree 3
N O T I C E
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
English 3