Operating Instructions; Taking Into Operation; Fuses; Technical Data - Truma S 3004 Instructions De Montage

Masquer les pouces Voir aussi pour S 3004:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14

Operating instructions

Taking into operation

The lighting of the control elements is activated by a proximity
switch. Touch from above on the middle of the cover. This
means that the lighting is switched on for approx. 20 seconds.
Each time the 12 V voltage supply is produced, the
sensor electronics calibrate the lighting. This can take
several seconds. Do not touch the cover during calibration.
Otherwise the heater is operated as stated in the operating
instructions of the respective heater.

Fuses

Depending on the model, a fuse (2 A) is installed in the sup-
plied power cable. Only replace faulty fuses with ones of the
same type.

Technical data

Power supply SELV (Safety Extra Low Voltage)
12 V DC (alternating current ripple < 1.2 Vss)
Current consumption
< 0.2 A (operation)
Quiescent current
< 1 mA
Weight
approx. 0.15 kg (additional weight after installation)
The right to effect technical modifications is reserved!

Declaration of conformity

The device has been tested by the DVGW and is entitled to
display the CE symbol. (Declaration of conformity – see op-
erating instructions for the respective heater). The previous
CE product ident number of the heater remains valid.
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

S 3004 pS 5004S 5004 eS 5004 e nl

Table des Matières