Toilet bowl is clogged
Too much toilet paper is used.
Set the [AUTO FLUSH] to [OFF], then unclog the toilet.
* Toilet may flush automatically during unclogging, and the water inside the toilet bowl may overflow.
Flushing starts when sitting on the toilet seat
This is not a problem. The pre-flush function is working. When the user sits on the toilet seat, the toilet bowl
becomes wet with a small amount of water to prevent it from getting dirty.
Dryer
The dryer does not work
The lower body sensor does not detect a user.
Sit on the toilet seat. Or change your sitting posture. For example, sit further back on the seat.
Clothes of a user are difficult to detect.
Allow the sensor to detect the skin of a user.
The air is not warm
The [DRYER TEMP] is set too low.
Press the button below [DRYER TEMP] indicator to adjust the temperature.
Warm air stops suddenly
The drying function has been used for 4 minutes.
Press the button below [DRYER] indicator again.
Dryer sound is noisy
When [DRYER TEMP] is set to high, the dryer sound becomes noisy due to the increase in the fan rotation
speed.
Set [DRYER TEMP] to medium or low.
Auto Seat/Lid Open and Close Function
The seat lid closes too quickly
The seat lid is pushed down during auto close.
Press the
(open/close) button. If the seat does not open or close by pressing the
turn off the power of the toilet and request repairs.
(Page
71)
(Page
67)
(Page
67)
85
Troubleshooting
(Page
67)
(open/close) button,