Choosing The Correct Size; Trimming The Device; Donning The Device - Blatchford Silcare Breathe SBTTCP22L Instructions D'utilisation

7 Choosing the Correct Size

It is important that the correct size is specified to
ensure proper fit and comfort in use.
7. Measure the circumference of the residual limb
4 cm up from its distal end.
8. If the circumference of the residual limb matches
one of the sizes in the table, choose the next size
down.
9. If the circumference of the residual limb is
between one of the sizes in the table, choose the
smaller size.
22
ü

8 Trimming the Device

The device may be trimmed to suit as required but never bellow the socket trim line.
We recommend using a rotating disc cutter to achieve a bevelled edge.
Leave enough material on the device so that its proximal edge can cover the edge of the socket.
Avoid trimming through the perforations.
Trim the proximal edge of the device to suit the shape of the user's socket.
If necessary, trim the proximal edge of the device in a wave pattern to reduce shear stress.
Where possible try to avoid abrupt changes of contour and sharp edges which could
cause tears in the silicone and fabric.

9 Donning the Device

Care must be taken during donning/doffing not to damage the device with fingernails or
sharp jewelry.
Do NOT pull or stretch the device.
1. Invert the device so that its silicone side points
externally.
2. Roll the device on the residual limb while
releasing any trapped air.
After donning the device, allow the user to wear it
for 10 minutes. If the user feels numbness, tingling
or any unusual sensation within 10 minutes, do the
following:
Note... Doff the device, and wait until normal sensation returns.
3. Don the device again.
4. If the user feels numbness, tingling or any unusual sensation again, stop using the device.
5. Add air-tight sleeve of choice.
23.5 25 26.5
ü ü ü
Size (cm)
28 30 32
ü ü ü
7
34 36 40
ü ü ü
938370PK1/1-0121
4 cm