Hydro Unit
Setting Function Codes for Hydro Unit and Remote Controller
Set function codes for various operation modes with the remote controller.
There are two types of setting.
1) Hydro Unit function code setting
2) Remote controller function code setting
Setting remote controller mode
<Setting Hydro Unit Function Code>
1
Press the TEST
buttons for four seconds or more
to enter the remote controller function code
setting mode.
2
Set the function code (CODE No.) with the
TEMP.
buttons. (CODE No.: 01 to 91)
3
Set data (DATA) with the TIME
4
Press the SET
5
The CL
button is enabled only before the SET
changed.
6
Press the TEST
<Setting Remote Controller Function Code>
1
Press the TEST
buttons for four seconds or more to enter the
remote controller function code setting mode.
2
Set the function code (CODE No.) with the
TEMP.
buttons. (CODE No.: 01 to 13)
3
Set data (DATA) with the TIME
4
Press the SET
5
The CL
button is enabled only before the SET
changed.
6
Press the TEST
+ SET
+ SELECT
buttons.
button to determine the settings.
button to end the settings.
+ CL
+ TEMP.
buttons.
button to determine the settings.
button to end the settings.
button is pressed and the function code is
button is pressed and the function code is
– 33 –
Installation Manual
EN
32-EN