Peavey PV6 Manuel D'opération page 14

PV 6 Specifications
®
Frequency Response
Mic Input to Left/Right Output
Total Harmonic Distortion
<0.01% 20 Hz to 20 kHz Mic to Left/Right Output
<0.005% Typical
<0.0007% Mic Pre-amp Distortion
Hum and Noise
Output Residual Noise S/N Ratio
Master Left/Right -98 dBu
-90 dBu
-84 dBu
Effects Sends -96 dBu
-84 dBu
(Hum and noise measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN)
-129 dBu (input terminated with 150 ohms)
Crosstalk/Attenuation
Adjacent Input Channels (1 kHz) >80 dB
Left to Right Outputs (1 kHz) >75 dB
Common Mode Rejection Ratio (Mic Input)
50 dB minimum (20 Hz to 20 kHz)
70 dB typical @ 1 kHz
Meters
4 segment, peak reading (0 db = +4 dBu)
Dimensions
7.55" wide x 9.717" deep x 2.7" high
(19.18cm x 24.68cm x 6.86cm)
Installation Note:
This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"
Weight
Without power supply: 3.9 lbs. (1.77 kg)
With power supply: 5.1 lbs. (2.31 kg)
14 Hz to 25 kHz +0 dB/-1 dB
(10 Hz to 80 kHz BW)
(22 Hz to 22 kHz BW)
(Ref: +4dBu)
102 dB
94 dB
90 dB
100 dB
88 dB
Signal/Overload Indicators
Red LED lights 3 dB below clipping
Power Requirements
Domestic: 15 V DC, 0.5 Amps; 7.5 Watts nominal
14
Test Conditions
Master Fader Down, Channel Levels Down
Master Fader Nominal, Channel Levels Down
All controls nominal, mic gain minimum
All controls off
All channel sends nominal, masters nominal