lopital Reflex 5100 5600 Mode D'emploi page 41

• Once the charger is connected to the Reflex, the controls
will go into 'sleep' setting (all functions are switched off) .
Make sure that you push the plug into the correct
position in the charging point.
Only the original charger for the Reflex may be used.
If you use another charger, Lopital cannot be held
liable for any consequences, such as damage to the
electronics.
Once the charger is connected to the Reflex, the controls will go into 'sleep'
setting (all functions are switched off).
The charger that must be used for the Reflex is the 'Mascot 2241'.
• When the indicator light on the charger goes green, the batteries are charged .
The charger can remain connected even when the batteries are completely charged .
Leaving it connected will not cause any damage .
• Disconnect the Reflex from the charger .
• Once activated, the Reflex is now ready for use (See paragraph 2.2 Activating) .
LEDs not on: Chair is in 'sleep' setting and cannot be
used .
Green light is on: Chair is ready for use
Red light blinks: Batteries must be charged (chair can still
be used) .
Red LED on: Batteries are completely empty and
must be charged immediately
Charge batteries in a well-ventilated, dry space.
After using the chair, connect it to the charger to maintain the batteries.
Charge the chair at least once a week!
For instruction videos go to www .lopital . c om or www . y outube . c om/user/LopitalNL
Reflex Shower-toilet chair | Instructions for use | 41
2
1
Figure 26 Charging point .
Figure 27 Battery indication on
control panel .