lopital Reflex 5100 5600 Mode D'emploi page 36

Option: Comfort leg support (Article number 6960 8026)
This option is only possible with the 5100 5605.
The comfort leg support provides the legs with additional support . The comfort leg
support can be adjusted in length as well as according to the sitting angle . The angle
of the leg support can be adjusted to 4 positions, as shown in figures 9, 10, 11 and 12 .
To change the seating angle, you have to release the locking pin . When you have
determined the correct position, lock the sitting angle of the comfort once again (see
Figure 13) . Make sure that the locking pin slips in well into one of the 4 holes.
Figure 9 to 12: Adjustable seating angle .
Figure 13: Locking pins .
To adjust the length of the leg support, you have to release the locking pin underneath
by loosen it a bit (see Figure 13) . Choose the right length for the leg support and tighten
the locking pin again .
Make sure that both the sitting angle and the length of the leg support are
locked properly as soon as they have to support a load.
36 | Instructions for use | Reflex Shower-toilet chair
Setting the angle of the locking pin
Setting the length of the locking pin