Technical Data; Before Starting The Equipment - EINHELL BG-ES 1231 Mode D'emploi

Anleitung_BG_ES_1231_SPK1:_
GB
Important! Due to the high risk of bodily injury to the
user, the equipment may not be used to grind up
branch or hedge clippings. Moreover, the equipment
may not be used as a power cultivator to level out
high areas such as mole hills.
For safety reasons, the scarifier may not be used as
a drive unit for other equipment or toolkits of any
kind, unless specifically advised to do so by the
manufacturer.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Mains voltage:
Power input:
Working width:
Number of blades:
Scarifying depth:
L sound pressure level:
pA
L sound power level:
WA
Vibration at the handlebars:
K uncertainty:
Protection class:
Protection type:
Weight:
14
10.12.2008 12:58 Uhr Seite 14

5. Before starting the equipment

The scarifier is delivered unassembled. The grass
basket and the complete push bar must be
assembled and mounted before using the scarifier.
Follow the operating instructions step-by-step and
use the pictures provided as a visual guide to easily
assemble the machine.
Fitting the push bar brackets (see Figs. 4 and 5)
Insert the push bar brackets (Fig. 4/Item 7) into the
provided openings (Fig. 4). Then fasten the brackets
with the retaining screws (Fig. 5/Item 14).
Fitting the lower push bar (see Fig. 6)
Slide the lower push bar (Fig. 6/Item 6) over the
push bar brackets. Do not forget to slide the
stress-relief clip (Fig. 6/Item 4) onto the tube
beforehand.
Screw the tubes together, using the screws
supplied (Fig. 7/Item 13).
Fitting the upper push bar (see Figs. 7-9)
Position the upper push bar (Fig. 1/Item 5) such
that its holes line up with the holes of the lower
bar.
Screw the tubes together, using the screws
230 V ~ 50Hz
supplied (Fig. 2/Item 13).
1200 W
Using the cable clips supplied (Fig. 8), attach the
31 cm power cable to the tubes of the push bars so that
it is possible to open and shut the ejector flap
8 double blades
(Fig. 9/Item 12).
-3 / 3 / 7 / 9 mm
Important.
Please ensure that the ejector flap can be opened
85 dB(A)
and closed easily!
99 dB(A)
2.71 m/s²
Assembling the grass basket
(see Figs. 10 and -13)
1.5 m/s²
Push both frame parts into each other (Fig. 10).
II /
Pull the grass basket over the metal frame (Fig.
IPX4
11).
Pull the rubber clips over the metal frame (Fig.
11 kg
12).
To hang the grass basket on the scarifier you
must lift the ejector flap (Fig. 13/Item 10) with
one hand and with the other hand take hold of
the grass bag by the handle and hook it onto the
scarifier from above (Fig. 13).
Important!
Before you ever hook the grass basket to the
scarifier you must ensure that the motor is switched
off and the cutting unit is not rotating.