Cooktop Controls Touch-Activated Electronic Control Models; Dual/Triple Circuit Element - KitchenAid Architect II Série Guide D'utilisation Et D'entretien

TOUCH-ACTIVATED ELECTRONIC CONTROL MODELS
WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
The electronic touch controls offer a variety of heat settings for
optimal cooking results. When melting foods such as chocolate
or butter, or when proofing bread, the surface cooking area can
be set to MELT & HOLD for minimal element operation.
For maximum element operation, all cooktop touch controls can
be set to HI when bringing liquids to a fast and rapid boil. Touch
the minus (-) keypad to immediately reach the HI setting.
NOTE: Where 240V installation is not available, this cooktop will
automatically adjust to 208V operation.
To Use:
1. Touch ON/OFF.
2. Touch the "plus" (+) or "minus" (-) keypads to increase or
decrease power.
3. To choose a power level between HI and MELT & HOLD,
touch and hold either the "+" or "-" keypad until the desired
level has been reached.
4. When finished cooking, touch ON/OFF to turn off surface
cooking area(s) individually, or touch ALL OFF to turn off all
elements at the same time.
Use the following chart as a guide when setting heat levels.
SETTING
Hi
Medium High
Between Med & Hi
Med
Medium
Medium Low
Between Med & Lo
6
COOKTOP CONTROLS
RECOMMENDED USE
Start food cooking.
Bring liquid to a boil.
Hold a rapid boil.
Quickly brown or sear food.
Maintain a slow boil.
Fry or sauté foods.
Cook soups, sauces and
gravies.
Stew or steam food.
SETTING
Lo
SIMMER
Keep Warm Function
Melt & Hold Function
Dual/Triple Circuit
Elements
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
Hot Surface Indicator Lights (on Touch Control models)
The Hot Surface Indicator Lights are located next to each of the
cooktop touch controls. The Hot Surface Indicator Lights will
glow as long as any surface cooking area is too hot to touch,
even after the surface cooking area(s) is turned off.
A
A. Hot surface indicator light
If the cooktop is on when a power failure occurs, the Hot Surface
Indicator Lights will remain on after the power is restored to the
cooktop. They will remain on until the cooktop has cooled
completely.

Dual/Triple Circuit Element

The dual-size and triple-size elements offer flexibility depending
on the size of the cookware. Single size can be used in the same
way as a regular element. The dual and triple sizes combine
single, dual and outer element and are recommended for larger
cookware, large quantities of food, and home canning.
A
B
A. Single size
B. Dual size
RECOMMENDED USE
Provide lowest simmer/heat
setting.
Simmer (range of simmer
temperatures).
Keep cooked foods warm.
Melt chocolate or butter.
Home canning.
Large-diameter cookware.
Large quantities of food.
C
C. Triple size