EMAK EF 95 Manuel D'utilisation Et D'entretien page 56

5. Check blade drive belt (2)
6. Replace blade drive belt (1)
(2)
7. Check and adjust parking
brake (2)
8. Check and adjust drive (2)
9. Check blade engagement
and brake (2)
10. Check all fastening elements 25 hours
11. General lubrication (3)
1) At the first signs of malfunction,
GB
contact your Dealer immediately.
2) This operation must be carried out
by your Dealer or an Authorised
Service Centre.
3) General lubrication should also be
carried out whenever the machine is
to be left unused for a long period.
Engine (4)
Change engine oil (also see paragraph
below) - Check and clean air filter - Replace
air filter - Check fuel filter - Replace fuel
filter - Check and clean spark plug points -
Replace spark plug
4) See the engine manual for the full list
and frequency.
Engine
Follow the instructions in the engine
manual.
Changing the engine oil
CAUTION: The oil discharge operation
is easier to perform if the oil is warm.
WARNING: Please dispose of used
engine oil in a manner that is
compatible with the environment. Used
oil must be taken in a sealed container
t o yo u r l o c a l s e r v i c e c e n t r e f o r
reclamation. Do not throw it in the
rubbish bin or pour it down a drain, on
the ground or into the water system.
Lubricating plan
To ensure that moving parts can move
freely, we recommend lubricating the
56
following points at least once a year.
25 hours
Use a cloth to clean all points to be
lubricated before greasing or spraying. Do
-- hours
not use water, so as to avoid possible
corrosion.
25 hours
Lubricating points
25 hours - Grease the grease nipples on the right
and left steering knuckles (23) using
multi-purpose grease.
25 hours
- Spray oil onto the bearings of the front
axle on the frame (22).
- Grease the toothed segments and
25 hours
steering pinion on the steering box (24)
using multipurpose grease.
- Grease the roller bearing and hub on the
front and rear axles (25) with multi-
purpose grease.
WARNING: The front and rear wheels
must be removed by an Authorised
Service Centre for greasing the axles and
bearings.
- Pivoting and bearing points: Lubricate all
movable pivoting and bearing points.
Carburettor
WA R N I N G : D o n o t m o d i f y t h e
carburettor. This could lead to
violation of exhaust gas emission laws.
Battery
The starter battery is located under the
bonnet.
The starter battery is always supplied from
the factory pre-charged.
WARNING
Danger if the starter battery is not
handled correctly!
Please comply with the following points to
avoid dangers from incorrect handling of
the battery!
- Do not store the starter battery in the
immediate vicinity of naked flames, do
not burn it or place it on heaters. Risk of
explosion.
- Keep the starter battery in a cool, dry
room (10 - 15 °C) over winter. Avoid
storing at temperatures below the
freezing point.