EMAK EF 95 Manuel D'utilisation Et D'entretien page 50

Use of accessories
WARNING!
- Danger due to incorrect accessories or
incorrect use of accessories!
- Only ever use genuine accessories from
the tractor manufacturer!
- Pay attention to the regulations on use in
the supplied operating instructions!
Using unauthorised accessories, or using
accessories incorrectly, can expose the
operator and other persons to significant
risks. The lawn tractor could be overloaded.
This can lead to serious accidents.
GB
Move the tractor with the engine off
WARNING!
- Danger when pushing on slopes!
- Only push the lawn tractor on flat
ground!
- On slopes, the lawn tractor could roll
downhill uncontrollably.
To move the tractor with the engine off
you have to unlock the lever by-pass.
With foot hydrostat drive:
The bypass lever (Fig. 16-17) is located in
the rear right wheel housing.
Bypass unlocking on T3 transmission (type
95-105)
- Pull out the bypass lever (17a) and hook
it in upwards.
- Release the brake.
Bypass unlocking on G700 transmission
(type 125)
- Push in the bypass lever (16a) and hook
it in upwards.
- Release the brake.
CAUTION: To avoid damaging the
t r a n s m i s s i o n u n i t , t h e l e v e r
engagement/release operation must
only be carried out when the engine has
stopped and the parking brake is on.
Starting and stopping the engine
Starting the engine
1. Sit on the operator's seat.
2. Press the brake pedal (6a) on the left
50
side down fully and lock it using the
locking lever (6b).
3. Make sure the mower mechanism is not
switched on. Check the position of the
toggle switch (3e) for this purpose.
4. Move the controller (3b) for the engine
speed to the top stop. The choke
symbol is located there, depending on
the equipment variant. If it is not, pull
the separate choke button (3a).
5. Insert the ignition key into the ignition
lock (3d).
6. Turn the ignition key to position "III"
and hold it there until the engine is
running.
CAUTION - To reduce strain on the
starter battery, do not attempt to start
for longer than about 5 seconds.
7. Then release the ignition key, it
automatically jumps to position "II".
8. Move the controller (3b) for the engine
speed to the operating position. In an
equipment variant with the choke
button, press it back in again (3a).
Switching off the engine
1. Switch off the mower mechanism (3e).
2. Move the controller (3b) for the engine
speed to the idling speed position.
3. Press the brake pedal (6a) and lock it
using the locking lever (6b).
4. Turn the ignition key (3d) to position "0".
5. Remove the ignition key.
WARNING
- Danger if the engine is hot!
- When stopping the engine, ensure that
hot engine components such as the
silencer cannot set fire to objects or
materials located nearby!
Driving with the tractor
WARNING
- Danger in case of inappropriate speed!
- Drive slowly, especially at the beginning,
in order to familiarise yourself with the
driving and braking properties of the
tractor!
- Before each change of direction, adjust
the driving speed so as to retain control