EMAK EF 95 Manuel D'utilisation Et D'entretien page 48

petrol fumes are inflammable. DO NOT
USE A NAKED FLAME TO LOOK INSIDE
THE TANK AND DO NOT SMOKE WHEN
REFUELLING.
- Check for fuel leaks, if any are found,
co r re c t b e fo re u s e. Co nt a c t a n
a u t h o r i s e d s e r v i ce wo r k s h o p i f
necessary.
Filling the tank
1. Switch off the engine if it is running
and remove the ignition key.
2. Wait until the engine has cooled down
somewhat (risk of explosion if the fuel
catches fire).
3. Open the bonnet (9, Fig.2).
GB
4. Open the tank cap (A, Fig.10) and pour
in the gasoline.
WARNING - Avoid overfilling the
gasoline tank.
5. Close the tank cap (A).
6. Close the bonnet (9).
Tyre pressure
Having the right tyre pressure is the main
condition for ensuring that the cutting
deck is perfectly horizontal and mows
evenly. Unscrew the valve caps and
connect a compressed air line with a gauge
to the valves.
Check the tyre pressure at regular intervals.
Please refer to the tyre for the necessary
inflation pressure.
WARNING: 1 PSI = 0.07 bar.
Fitting the grass-catcher or stone-guard
WARNING: Never use the machine
without having fitted the grass-
catcher or stone-guard.
Hooking in the fill-level sensor of the
grass catcher
The fill-level sensor uses a horn to signal
when the grass catcher must be emptied.
The grass catcher must be removed in
order for the fill-level sensor to be fitted.
The fill-level sensor (11a) must be pushed
into the opening in the rear wall. Make sure
the fill-level sensor is in the correct
position. Push it into the opening straight
and without excessive force, until you can
feel it engage.
48
Hooking in the grass catcher
1. Hold the grass catcher with one hand
on the catcher handle (12a) and your
other hand on the holding opening at
the back (12b).
2. Place the grass catcher symmetrically
onto the guide (12c).
3. Use your other hand to tip the grass
catcher slightly forward (13) so the
front part of the grass catcher engages.
4. Now swivel the grass catcher back
down (14a).
5. Check the grass catcher is correctly
seated (Fig. 15).
If you decide to mow without the grass-
catcher, you can mount an optional stone-
guard kit.
Checking the safety devices
Check the safety devices each time before
the lawn tractor is started.
WARNING
- Danger when checking the safety
devices!
- The safety devices are only allowed to be
checked from the driver's seat, and when
no other persons or animals are in the
vicinity!
Carry out all checks on level ground so that
t h e l aw n t r a c to r c a n n o t ro l l away
inadvertently.
Checking the brake contact switch
The brake contact switch ensures that the
engine cannot be started if the brake is not
applied.
1. The engine is off.
2. Sit on the operator's seat.
3. Release the parking brake by pressing
the brake pedal (6a).
4. Attempt to start the engine (ignition
key in position III).
CAUTION: The engine is not allowed
to start!
Checking the mower mechanism contact
switch
The mower mechanism contact switch