Automatic Night Vision; Expanding Multiple Cameras; General; Registration Of Extra Cameras - Alecto DVM-50 Mode D'emploi

Select a camera:
1. Press 4x on the
2. Press the
A ' ' behind the camera number will indicate that a camera is logged in.
The 'scan' function allows the parent unit to show every camera for 10 seconds; note, if
the camera is switched off or out of range, the out of range picture will be shown and the
out of range beep tones will sound.
3. Press 1x on the
See chapter 5 on how to add additional cameras.
4.4

AUTOMATIC NIGHT VISION:

The baby unit has 6 built in infrared LEDs; These LEDs will automatically turn on when the baby unit
detects darkness and turn off again when it gets light.
These LEDs can illuminate objects up to a distance of about 2 meters.
Note that when the night vision LEDs are turned on, the image on the parent unit will be displayed in
black /white.
Attention: infrared beams cannot be perceived by the human eye; it is not possible to detect that the
LEDs have been switched on with the naked eye. However, depending on the type infrared LED there
may be a red glow which is visible.
5

EXPANDING MULTIPLE CAMERAS

5.1

GENERAL:

The DVM-50 parent unit can register up to 4 cameras. The parent unit can select the desired camera
by scrolling through the menu. Using the menu on the DVM-50 parent unit you can select the desired
camera or you can rotate all the connected cameras using the (scan function).
Note: the receiver does NOT automatically switch to the camera where sound is detected.
Expansion Cameras (DVM-51) are available through the Alecto service desk either by phone: 073
6411 355 (NL), 03 238 5666 (B), 0180 503 0085 (D), or via the website at: www.alecto.info.
5.2

REGISTRATION OF EXTRA CAMERAS:

1. Connect the power adapter to the new baby unit, put the other end of the adapter into a 230V elec-
trical outlet and turn on the camera..
2. Press the
3. Use the
+
A ' ' behind a camera number will indicate that a camera is already logged on to a specific
connection. If you connect a new camera to this number, the connection with the old camera
will be lost; preferably chose a camera number without a ' ' next to it.
4. Press the
+
5. Press once on the
6. Within 10 seconds, press once on the PAIRING button located at the back of the new camera. The
light indicator on the front of the camera will flash quickly.
7. After a few seconds, the parent unit will have found the new camera and the picture will be shown
on the display of the parent unit.
button.
-
and keys to select the camera.
+
button to save the setting and exit the menu.
button on the parent unit 4x.
-
and buttons to select a free 'camera connection'.
button for 2 seconds button until the picture
button, the light will flash quickly.
appears.
31