Installation; Baby Unit; Parent Unit - Alecto DVM-50 Mode D'emploi

3

INSTALLATION

3.1

BABY UNIT:

Power:
1. Connect one of the included 6V power adapters into the 6V DC socket of the baby unit.
2. Plug the power adapter into a 230V electrical outlet.
Only use the supplied power adapter model number 5E-AD060080-E.
When used as a baby monitor: Make sure the baby cannot touch the baby monitor or the
cord. Place the baby unit at least 2 meters away from the baby and tape up any additional
long wires with tape or special wire ties.
Wall mounting:
Drill two holes next to each other in the wall 6.7 cm apart and insert two screws. Leave the screw head
out by a few millimetres.. Hang the baby unit on the wall by sliding the notches on the camera stand
down onto the screws. Tie the adapter cord neatly up with special wire ties.
Placement tips:
• When used as a baby monitor, place the baby unit a minimum distance of 2 meter away from your
baby and make sure the power adaptor cord is safely tucked away.
• For an optimum connection range, it is preferred to set the baby unit as high as possible and away
from large metal surfaces.
3.2

PARENT UNIT:

Power:
The parent unit can be powered directly from the supplied rechargeable battery, or the included power
adapter. When you connect the power adapter it will also charge the battery so that the parent unit can
be used cordless.
Battery:
1. Open the battery compartment by sliding the battery cover on the back off.
2. Connect the plug in the battery compartment and insert the battery according to the illustration.
3. Slide the battery cover back onto the parent unit.
Connecting the plug and inserting the battery without force.
Only insert the supplied rechargeable Li-ion Polymer battery (3.7V,1500mAh).
Power adapter:
1. Connect the 6V power adapter to the other 6V DC socket located on the side of the parent unit.
2. Plug the adapter into a 230V electrical outlet.
Use only the supplied power adapter model number 5E-AD060080-E.
Make sure that the power adapter cord cannot cause any tripping or falling. Tie up any long wires with
tape or special purpose wire ties.
Charging:
The battery will begin charging once you have connected the parent unit to the power adapter and
then the other end of the adapter into a 230V electrical wall outlet.
• The battery needs to be charged for at least 15 hours before using it the first time, even if the bat-
tery indicator shows fully charged.
• The charging circuit of the battery is electronically controlled so there is no danger of overcharging.
You can leave the power adapter permanently connected.
• If you are not using the set for long periods of time (> 2 months), it is advisable to take the adapter
out from the electrical wall outlet and remove the battery from the parent unit. When you begin
using it again, first charge the battery.
29