Connecting Headphones - VINCENT SV-123 Manuel D'utilisation

STEREO PREAMPLIFIER OUTPUT
You only need the "PRE" sockets (15) if you want to
use a separate stereo amplifier or two mono ampli-
fiers to supply two additional loudspeakers.
This makes sense if you intend to use two more loud-
SV-123
A set of headphones equipped with a 6.3 mm
jack can be plugged into the "PHONES" socket
(9) on the front of the appliance. When this hap-
pens, the system's loudspeakers and the "PRE"
CONNECTING THE POWER CABLE
Check whether the wall socket provides the appro-
priate mains power, which is the case if it is sup-
plied with 230 V AC 50 Hz. Push the plug for
non-heating appliances on the power cable sup-

CONNECTING HEADPHONES

speakers for stereo music playback, perhaps even in
another area. These loudspeakers are then connec-
ted to the outputs of the additional amplifier.
1
INPUT
preamplifier output (15) are muted. The volume
should be turned down before plugging in or
unplugging. All headphones with an impedance of at
least 32 Ohms can be used.
plied firmly into the power socket (23) on the back
of the appliance. Plug the other end of the power
cable into a mains socket.
separate
Stereo amplifier
Vincent
33