ETNA KI460ZT Mode D'emploi page 43

ERRORS
Symptom
The hob is not working and
nothing appears in the display.
A fuse blows as soon as the
hob is switched on.
Error code ER03.
Error code E3.
Error code E2.
Fault code E6.
Error code L
Other fault codes.
Possible cause
There is no power supply due
to a defective cable or a faulty
connection.
The appliance is incorrectly
connected.
The control panel is dirty or
has water on it.
Unsuitable pan used.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Child lock is activated.
Defective generator.
Solution
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Clean the control panel.
Use a pan suitable for
induction cooking.
The appliance has been
switched off because of over
heating.
Have your connection
changed.
Switch the child lock off.
Contact the service
department.
EN 21