Amana AMAP081BW Guide D'utilisation page 6

Prepare Window Opening
1.
Measure and mark center line
Width of window opening
Measure the width of the window opening (A). Mark the center
line (B) of the window on the inside windowsill.
2.
Attach upper foam seal
Attach the foam seal with adhesive strip to the bottom of the
window sash.
6
A
B
Center line
Foam seal
Preparing Window with Storm Window
or Other Obstruction
Follow the steps in "Prepare Window Opening".
If possible, remove the storm window frame or other obstruction.
If the storm window frame or obstruction CANNOT be removed,
a wood spacer will be required to ensure that the air conditioner
slopes to the outside. This will allow condensation and rainwater
to drain away. Make sure that drain holes or slots are not caulked
or painted shut.
1.
Measure size of spacer needed
1
" (3.8 cm)
/
1
2
Min.
Spacer
Using a level and measuring tape, determine thickness of wood
spacer needed to allow the air conditioner to slope downward
slightly to the outdoors. The block should provide at least 1/2"
(1.27 cm) of height above the obstruction.
2.
Place block on windowsill
A. Piece of wood
B. Windowsill
C Indoors
D. Outdoors
E. Storm window frame
or other obstruction
Place wood spacer on windowsill. Spacer should be at least the
full width of the air conditioner cabinet.
/ " (1.27 cm)
1
2
Min.
Obstruction
(1.27 cm)
/ "
1
2
1 "
/ (3.8 cm)
1
2
Min.
Min.
E
A
B
C
D