Amana AMAP081BW Guide D'utilisation page 11

6.
Remove right-side screws
Remove the screws from the right side of the cabinet.
7.
Remove chassis
IMPORTANT: To avoid damage, do not pull or lift near the top
of the unit.
Hold the cabinet while pulling on the base handle to carefully
remove the unit.
Install Top Channel and Side Bracket
1.
Attach foam gasket
Place air conditioner on a hard, flat surface. Attach the foam
gasket to the top angle channel.
2.
Install top angle channel
Attach the top angle channel to the cabinet with four 5/16"
hex-head screws.
3.
Slide in side panels
Slide the "I" section of the window panel into the side bracket
f the cabinet. Do this for both sides.
4.
Attach side panels
Insert the top and bottom legs of the window filler panel frame
into the top angle channel and bottom channel. Secure with
5/16" screws. Repeat on the other side and install side retainer
into cabinet.
Install Air Conditioner in Window
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
IMPORTANT:
Be sure your air conditioner does not fall out of the opening
■
during installation or removal.
The place where the power cord exits the air conditioner
■
should be no more than 6 ft (183 cm) from a grounded outlet.
To maximize cooling efficiency and air circulation, do not
■
block the air intake or discharge louvers in the front panel.
To reduce cycling on and off of the compressor and reduce
■
the risk of freezing up or damage to the unit, do not block the
louvers on the outside of the air conditioner.
5/16"
screws
11